This device may then be swagged or left as-is. Swagging involves compressing the metal tube to constrict it against the powdered thermal conductor ensuring maximum heat transfer potential. Although beneficial to a point, swagging is expensive and many low cost cartridge heaters are left non-swagged. To reduce the cartridge heaters, it usually requires a swaging machine. The two heater element power supply leads exit at the uncapped end of the tube. These leads may be axial for straight line installations or radial for applications which require 90° lead orientation.
The cartridge heater is installed via a close fitting hole drilled into the heated part body. The tube needs to fit tightly into the hole to ensure maximum heater efficiency and with average manufacturer specifications requiring a 0.010 inch (0.25 mm) difference between tube and hole diameters. The output of the cartridge heater is controlled by a surface mounted thermocouple or a remote microcontroller which maintains the part at an optimal temperature. These heaters are available in a range of sizes from 1/4 inch (6.35 mm) to 1 inch (25.4 mm) in diameter. Cartridge heaters are power rated in “watt density” units based on the diameter, length, and wattage of the heater.
|