Section 2 - Coil Production Line
(1) 6 sets Full auto resistance coil winding machine (item RS-328B), automaticly wind the resistance wire to screw shape.
(2) 1 set Tri-tank Cleaning Machine (with hanger frame), After coiled the spiral wire, clean by ultrasonic wave vibration to remove the dirt.
(3) 1 set Hot air Oven(300 OC), Drying the coiled spiral wire for latter steps
(4) 1 set End of the needle plug pressing machine, this machine will heating the bottom part of the needle (the bar) and sealing plug (plastic) automatic and press together.
(5) Coil assemble machine, current coil assemble machine is very strict of the straightness of the coil, if there is any slightly inconsistent, the machine will say wrong. We recommend to assemble by human, test the resistance value manual before filling. Need 8-10 people for coil assemble.
(6) Welding Machine, fixed upper and lower terminal pins with the coil wire.
Section 3 - Filling
Fixed the heating wier int the center of the tube, filled with MGO powder, we have two kinds of filling machine: single-deck guiding pipe and double (three) deck guiding pipe. The single-deck guinding is in high production effciency, but lack of tap density. The double-desk guiding is approach of Austra or CSM machine. To compare with the single-desk guinding, the production effciency is a little lower, however, the tap density more than 2.35g/cm3
1. MGO powder filling machine 4 sets
(1) Item: TL24-1000 PLC USD 5800/set (single-desk guiding)
(2) Item: FM24-1500 PLC USD 8500/set (Tri-desk guiding) |